Page 1 of 1

Water Sensor

PostPosted: 12 Apr 2017, 08:22
by Benjamin
Hi all,

I have bought the water sensor and I am following the instructions to take some measurements of the water, but the senson start to check te sensor and do not advance in the measurements.

Do someone has similar experience?

if yes, Could you share me how can I solve it?



Re: Water Sensor

PostPosted: 02 May 2017, 16:06
by Dmitry_Orlov
Dear Benjamin,
I recommend you to do the following:
1. Place the metal cylinder on the Bio-Well device.
2. Connect calibration wire to the metal cylinder.
3. Connect the water sensor banana jack to the calibration wire.
As a result you will have two wires connected to each other. So the wire connection between metal cylinder and water sensor will be longer - thus increasing the electrical capacity. It will solve your problem.
Please try and revert back to us.

Re: Water Sensor

PostPosted: 02 May 2017, 21:05
by Benjamin
Hi Dmitry,

Thanks a lot! Now it is working in good Shape!